MATERIAL SAFETY DATA SHEET SurfaceAide® XL Section 1 — Chemical Product and Company Information Coating Specialists LLC Telephone: (248) 292-0880 1030 Doris Road Fax: (248) 292-0881 Auburn Hills, MI 48326 Chemtrec – 24 Hours Emergency Response: (800) 424-9300 Generic Description: Organosilane in water Physical Form: Liquid Color: Colorless to pale white Odor: Characteristic odor HMIS Hazard Rating: Health 1 Flammability 0 Reactivity 0 Section 2 — OSHA Hazardous Components CAS Number Wt.% Component Exposure Limits 027668526 1.44 3(tryhydroxysilyl)propyldimethyl octadecyl ammonium chloride none Section 3 — Effects of Overexposure Acute Effects Eye: Causes pain, reddening and swelling of the conjunctiva Skin: May cause irritation similar to a rash with localized edema, reddening, and raised lesions Inhalation: Excessive or prolonged inhalation of fumes or lists may cause adverse effects including mental impairment Oral: May be harmful or fatal if swallowed Prolonged/Repeated Exposure Effects Skin: No untoward effects Inhalation: No untoward effects Oral: No untoward effects Signs and Symptoms of Overexposure: No known applicable information Medical Conditions Aggravated by Exposure: No known applicable information The above listed potential effects of overexposure are based on actual data, results of studies performed upon similar compositions, component data and/or expert review of the product. Please refer to Section 11 for detailed toxicology information. Section 4 — First Aid Measures Eye: Immediately flush with water for 15 minutes. Get medical attention. Skin: Get medical attention if irritation or ill effects develop or persist. Inhalation: Remove to fresh air. Get medical attention if ill effects persist. Oral: Get medical attention if irritation or ill effects develop or persist. Comments: None Section 5 — Fire Fighting Measures Flash Point (closed cup): >212 Degrees F. Autoignition Temperature: Not Applicable Extinguishing Media: Use water spray, dry chemicals, foam or carbon dioxide. Do not flush into a storm drain or public sewer Fire Fighting Procedures: Use proper personal protection clothing Unusual Fire Hazards: Not known unusual fire or explosion hazards associated with this material Hazardous Decomposition Products: Thermal breakdown of this product during fire or very high heat conditions may evolve hazardous decomposition products: Carbon oxides and traces of incompletely burned carbon compounds; Nitrogen oxides; Chlorine compounds; Silicon dioxide; Formaldehyde. Section 6 — Accidental release measures Containment/Cleanup: Use absorbent material to collect and contain for salvage or disposal Section 7 — Handling and Storage Storage: Store below 100oF Other Precautions: None. Section 8 — Exposure Controls / Personal Protection Respiratory Protection: In the course of normal use, consistent with the product’s labeling, respiratory protection is not required. Care should be taken to avoid remaining in an enclosed area where a significant concentration of product mist or vapors are present. Ventilation: Normal ventilation has been found to be generally adequate. The end user must determine if the process or methods involved with the use of this material requires any additional or special ventilation. Protective Gloves: If end user uses this material on a regular basis, then rubber, butyl, neoprene or plastic gloves should be worn to avoid skin contact. MATERIAL SAFETY DATA SHEET Section 8 Cont’d— Exposure Controls / Personal Protection Eye protection: Safety glasses with side shields are recommended. Other Protective Clothing or Equipment: Not generally required under normal working conditions. The end user must determine if the process or methods involved require other personal protection clothing and/or equipment. General Work/Hygienic Practices: Do not eat, drink or smoke in areas where chemicals are being stored or handled. Wash hands thoroughly before handling food or beverages. Section 9 — Physical and Chemical Properties Physical Form: Liquid Color: Colorless to pale white Odor: Characteristic odor Specific Gravity @ 25C: 1.00 Viscosity: 5.00 CST Freezing/Melting Point: 32°F / 0°C Boiling Point: 212°F / 100°C Solubility in Water: Completely soluble in water Vapor Pressure @ 25C: Not Determined Vapor Density: Not Determined pH: 5-6 Typical Volatile content: N/D Note: The above information is not intended for use in preparing product specifications. Contact Coating Specialists LLC before writing specifications. Section 10 — Stability and Reactivity Chemical Stability: Stable Hazardous Polymerization: Hazardous polymerization will not occur Conditions to Avoid: Protect from freezing Materials to Avoid: Strong oxidizing material agents Comments: None Section 11 — Toxicological Information Product had Toxicity Category IV Non-Irritating based on Acute Dermal and Acute Eye Irritation Studies. Acute dermal toxicity LD50 > 5,050 mg/kg. Acute oral toxicity LD50 > 5,050 mg/kg. Section 12 — Ecological Information Environmental Impact of Material This product contains pesticides that are toxic to aquatic life. Product usage following product label and recommended instruction guide poses no risk to the environment. Do not discharge material into lakes, streams, ponds, estuaries, oceans, or other waters unless in accordance with the requirements of a National Pollutant Discharge Elimination System (NPDES) permit. Inactivation of solutions containing this product may be accomplished by the addition of an anionic surfactant in a quantity equivalent to the percent active ingredient. Section 13 — Disposal Considerations RCRA Hazard Class (40 CFR 261) When a decision is made to discard this material, as received, is it classified as a hazardous waste? Yes Federal Hazardous Waste Code Characteristic Waste: Ignitable: N/A Corrosive: N/A Reactive: N/A TCLP: N/A N/A = Not Applicable Comments: State or local laws may impose additional regulatory requirements regarding disposal. Call Coating Specialists Group at 1-877-211-4533 if additional information is required Section 14 — Regulatory Information Contents of this MSDS comply with the OSHA Hazard Communication Standard 29CFR 1910.1200 For “Right to Know” States, such as New Jersey, Pennsylvania, and Massachusetts, there are no ingredients listed. TSCA Status: All chemical substances in this material are included on or exempted from listing on the TSCA Inventory of Chemical Substances. DSL Status: All chemical substance in this material are included on or exempted from the Canadian DSL Inventory. EPA SARA Title III Chemical Listings: Section 302 Extremely Hazardous Substances: None Section 304 CERCLA Hazardous Substances: None Section 312 Hazard Class: Acute: N Chronic: N Fire: N Pressure: N Reactive: N Y =Yes N = No Section 313 Toxic Chemicals: None Supplemental State Compliance Information: California: This product contains the following chemical(s) listed by the State of California under the Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65) as being known to cause cancer None Known Section 15 — Other Information Prepared by Coating Specialists LLC. This information is offered in good faith as typical values and not as product specifications. No warranty, either expressed or implied, is hereby made. The recommended industrial hygiene and safe handling procedures are believed to be generally applicable. However, each user should review these recommendations in the specific context of the intended use and determine whether they are appropriate. *** This is the last page ***